Safety Bulletins
SAFETY TIP 1 - Replace your auto-belay cables every year!
It is recommended that you replace your auto-belay cables every year. Please abide by the manufacture recommendations and the consumer products safety commission ruling to maintain the safety of you, your staff and your climbers. DO NOT use aftermarket cables. YOU MUST replace with Extreme Engineering specific Belay in the Box cables only!
Related files: SAFETY TIP 7 Auto-belay Cable Inspection.pdf
__________________________________________________________________
NEW FREQUENTLY ASKED QUESTIONS FOR 2010
Attached are the new Frequently Asked Questions for 2010. The attachment goes over commonly asked questions in regards to mobile and stationary climbing walls, jumper systems, and other adventure products.
Related files: FAQ Sheet.pdf
__________________________________________________________________
Extreme Engineering - Determining Auto-belay Cable Length
Attached is a form used to determine your auto-belay cable length for stationary and mobile climbing walls. Please refer to this attachment for details. The form uses an equation that will assist you in the correct length for your auto-belay system.
Related files: Auto-belay Cable Calculation Form.pdf
__________________________________________________________________
Extreme Engineering - Roster of state inspectors
Extreme Engineering has gathered the roster of state inspectors for your convenience. Attached is the current list of state inspectors in your area for 2010. This attachment was created by the consumer products of safety. Please feel free to contact them if you have any additional questions or concerns.
Related files: amuse officials.pdf
__________________________________________________________________
Product Manuals
